![]() ![]() I am computer and network literate but not an expert. Also is it better to use WiFi connections between the mesh units or can I wired them with CAT6. I have 2 questions 1/ is it possible and efficient to have both network using the same SSID and address range OR 2/ if yes how do I proceed methodically to have things working fine. which is not very convenient for me regarding home devices like TV being wired and now I cannot control my wired devices using mobile devices. Finish the scanning process by following the on-screen instructions. ![]() When the app setup the mesh, I was asked to choose another SSID = the mesh uses the range 192.168.68.1. To scan with TP-LINK USB Printer Controller, right-click the printer and select Network Scanner. It was and still available in the same range 192.168.1.1 but with not a good coverage in the house, reason for the mesh. A WiFi network setup in the router was operational before setting up the mesh. I have a wired network, a switch TP-Link 1600G-52PS wired to the router, the wired network uses IP range 192.168.1.1 - 254 with auto select range 100 to 199 by the router which is OK with me. I have 2 TP-Link Deco M9 Plus, one is connected wired to the router, the other is connected WiFi to the first deco. Hi, new to this community, I am in Australia, ISP is Aussie broadband, Internet connection is NBN Fiber to the Node, I use a modem router TP-Link Archer 2100 One Mesh ready. If so, it is suggested to configure the router in the bridge mode to avoid issues, such as double NAT which could block services. Home » tp-link » tp-link AX5400 Wi-Fi 6 Router Installation Guide. Your ISP may also have directions on how to set the device to bridge mode. If your router is a combination of a modem & router from your ISP, check with your ISP for instructions on how to turn off the wireless capabilities. This will ensure a reliable internet connection and seamless roaming while on the Deco mesh network. You will then have a single SSID for your whole network, with minimal wireless interference. If possible, turn off your existing router’s Wi-Fi. Configuring the Deco with the same SSID might lead to various issues. If you want to use Deco along with your existing router, do the following:ĭefine a different network name (SSID) and password from those of your current network. ![]() Since all the clients are managed by the root router, some advanced features will not be available on the Deco app, including Antivirus, Parental Controls, Port Forwarding, Address Reservation, TP-Link DDNS, etc. Please make sure you have enabled the DHCP server function on the root router. When the deco in the AP mode, you can connect more than 1 Deco unit to the router directly.Īdditionally, the Deco system will not act as a DHCP server to assign IP addresses to the clients. Note: When the Deco in the Router mode, it’s not suggested to connect more than 1 deco units to the Router directly, because it may cause network loop. If you plan to install Deco unit(s) with your existing wireless router, here are two ways you can set that up. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |